Miele PWM 906, Инструкции по эксплуатации и монтажу

Страница: 93 / 100

Supervisor level
93
Only cold water is used for the main
wash.
– Warm
Hot water is also added for the main
wash.
Hot water can only be added if the
wash temperature is above 30°C
(86°F).
Program cycle times will be longer if the
machine is not connected for hot water;
this may mean that the “Time left”
display is incorrect.
First rinse
You can select the water type for the
first rinse in some programs.
– Cold (factory default)
Only cold water is used for the first
rinse.
– Warm
Hot water is also added for the first
rinse.
Final rinse
You can select the water type for the
last rinse in some programs.
– Cold (factory default)
Only cold water is used for the final
rinse.
– Warm
Hot water is also added for the final
rinse (only possible for programs with
a temperature of at least 60°C
(140°F)).
Low water pressure
If the water pressure is below 100 kPa
(14.5 psi), the program will be
cancelled and the error
message
Check water intake will
appear.
If the on-site water pressure cannot be
increased, activating the setting
Low
water pressure will prevent the program
from being cancelled.
Factory default: No
Automatic dispensing
Automatic dispensing via an external
dispensing system can be activated
Factory default: Off
CapDosing
You can choose whether
CapDosing
is
displayed in the program settings.
Factory default: On