en - Warning and Safety instructions
131
- Items (e.g. mops and floor cloths) that have been treated with inflammable cleaning
agents or which contain residues of acetone, alcohol, benzene, petrol, kerosene, stain
remover, turpentine, wax and wax remover or other chemicals.
- Items which have been splashed with hair lacquer, hair spray, nail varnish remover or
similar substances.
Wash heavily soiled items thoroughly by increasing the amount of detergent and selecting
a high washing temperature. If in doubt, wash the items several times.
In many programmes, the heating phase is followed by a cooling down phase to ensure
that the items are not too hot to handle when you remove them (this also avoids the
danger of the laundry self-igniting). The programme is not finished until the cooling down
phase is complete. Ensure that you always wait until the end of the programme before re-
moving the laundry.
Technical safety
Before setting up the tumble dryer, check it for any externally visible damage.
Do not install or use a damaged tumble dryer.
Do not connect the tumble dryer to the power supply by an extension lead (fire hazard
due to overheating).
Fire hazard. This tumble dryer must not be connected to a controllable socket (e.g. a
timer). There is a risk of the laundry igniting if the tumble dryer’s safety cooling-down
phase is interrupted.
The electrical safety of this tumble dryer can only be guaranteed when correctly earthed.
It is essential that this standard safety requirement is observed and regularly tested. If in
any doubt, please have the electrical installation inspected by a specialist. Miele cannot be
held liable for the consequences of an inadequate earthing system.
Unauthorised repairs could result in unforeseen dangers for the user, for which Miele
cannot accept liability. Repairs should only be undertaken by a Miele authorised techni-
cian, otherwise any subsequent damage will not be covered by the warranty.
Faulty components may only be replaced by genuine Miele spare parts. Miele can only
guarantee the safety standards of the appliance when Miele replacement parts are used.
In the event of a fault and for cleaning and maintenance purposes, the tumble dryer
must be disconnected from the power supply. The tumble dryer is only disconnected from
the power supply, if:
- It is switched off at the wall socket or the plug is withdrawn.
- The mains fuse is disconnected.
- The mains fuses have been completely removed.
See also “Installation – Electrical connection”.
The tumble dryer must not be used in non-stationary installation sites (e.g. on a ship).
Follow the instructions in “Installation” and “Technical data”.
The tumble dryer may only be operated when the ducting has been installed and the
room is sufficiently ventilated.
The vent ducting must never be installed in any of the following flues or shafts:
Содержание PDR 514
