What to do if, . . .
Cause . . .
Remedy . . .
. . . the “Pre-wash”, “Main
wash” or “Rinse 1-2” indica-
tor lamp is flashing?
There is an internal problem.
Restart the programme. If the
indicator lamp starts flashing
again, call the Service Dept.
. . . The “Rinse & hold” indi-
cator lamp is flashing?
The spin speed setting has
been set to “Without final spin”.
Select a spin speed setting.
. . . The “Final spin” indica-
tor lamp is flashing?
The final spin has not taken
place. The machine detected
an imbalance.
–
Redistribute the laundry load.
–
Select a spin speed.
–
Turn the programme selector
to “Spin”.
. . . The “ON” indicator lamp
is flashing?
The child-safety feature is
activated, and the programme
has been changed.
Go back to the programme
originally selected.
. . . The wash is too wet after
the final spin?
The spin speed selected was
too low.
Select a higher spin speed next
time.
The load was not evenly
distributed in the drum, and the
laundry was spun at a reduced
speed to protect the machine.
Mix large and small items in a
load to avoid imbalance.
The drain pump or lint trap is
clogged.
Clean the drain pump or lint
trap.
. . . The machine shakes dur-
ing the spin cycle?
The four feet are not resting
evenly on the floor.
Level the machine (see
Installation Section).
The shipping struts have not
been removed.
Remove the shipping struts.
Problem solving guide
32