Installation
The appliance must be built in
before it can be used. Otherwise it
poses an electric shock hazard.
^
Draw a line inside the housing unit to
mark the middle of the unit as
illustrated.
^
Position the fitting bracket on this
middle line. Use the indented mark
on the bracket to guide you.
^
Fit one screw
a
into the centre of the
first long slot.
^
Check the alignment with the front
edge of the unit and with the middle
line, and then fit another screw
a
into the other long slot.
^
Then tighten both of these screws.
^
Place the appliance in the housing
unit and using your hands push on
both sides of the back of the oven
interior to move the appliance into
position. It will engage in position
when it is correctly installed.
^
Check that it is correctly aligned.
^
If it is not aligned correctly, carefully
pull it back out of the niche and
realign it by slightly adjusting the
position of the bracket on the long
slots.
Installation
52
Содержание M 8261-1
Страница 54: ...54 ...
Страница 55: ...55 ...
Страница 56: ...Alteration rights reserved 0508 M 8261 1 M Nr 07 088 740 01 ...