Miele KM 6304, Инструкции по эксплуатации и монтажу, Страница: 67 / 80

Installing the cooktop
Preparing the worktop
^
Make the worktop cut-out according
to the dimensions given in the
building-in diagram. Remember to
maintain the
minimum safety
distances (see "Safety instructions
for installation").
^
Seal the cut surfaces with a suitable
heat-resistant sealant to avoid
swelling caused by moisture.
Make sure that the sealant does not
come into contact with the top of the
worktop.
No spring clamps are needed to
install the cooktop. The seal
underneath the cooktop will hold it
securely on the worktop.
Any gap between the frame and
worktop will reduce with time.
Connecting the mains cable to the
appliance
The mains cable must only be
connected to the appliance by a
qualified and competent electrician
in strict accordance with current
local and national safety regulations.
^
Follow the instructions in the wiring
diagram (see "Electrical connection -
Wiring diagram").
Installing the cooktop
^
Feed the mains connection cable
down through the cut-out.
^
Place the cooktop centrally in the
cut-out. When doing this, make sure
that the seal under the cooktop sits
flush with the worktop on all sides.
This is important to ensure an
effective seal all round.
Do not use sealant (e.g. silicone).
If the seal does not meet the worktop
correctly on the corners the corner
radius (
ß
R4) can be carefully
scribed to suit.
^
Connect the cooktop to the mains.
^
Check that the cooktop works.
Cooktop with frame or bevelled edge
67