Miele KM 5947, Инструкции по эксплуатации и монтажу

Страница: 51 / 84

... one of the following has occurred:
– The Booster has deactivated early
automatically.
– The power level has been reduced.
– The cooking zone is not working in
the usual way at the power level set.
The overheating protection mechanism
has been triggered (see "Overheating
protection").
... a zone operating at power level 9
is automatically reduced if the zone
or extended zone linked to it is also
operating at power level 9.
This is not a fault. Operating both zones
at power level 9 would exceed the
permitted maximum power level for the
two zones.
... the food in the pan hardly heats up
or does not heat up at all when the
Auto heat-up function is switched on.
This could be because:
– there is too much food in the pan.
– the pan is not conducting heat
properly.
Select a higher continued cooking
setting next time, or start cooking at the
highest setting and then turn down to a
lower setting manually later on.
... The cooling fan continues to run
after the appliance has been
switched off.
This is not a fault. The fan will continue
running until the appliance has cooled
down. It will then switch itself off
automatically.
... an
F
appears in the display for the
rear cooking zones, an
E
appears in
the display for the front cooking
zones and numbers appear in the
timer display.
FE99:
The overheating protection mechanism
for the induction coil has been
triggered. The cooking zone can be
used again as soon as it has cooled
down to a safe level.
With other fault messages:
Interrupt the power supply to the hob
for approx. 1 minute.
If the problem persists after
reconnecting the appliance to the
power supply, please contact the Miele
Service department.
Problem solving guide
51