Appliance faults
In the event of damage or a defect,
switch off the appliance immedi-
ately. Turn off the gas supply tap, and
disconnect completely from the
electricity supply. If the appliance has
not yet been fully installed, the
electricity cable must be disconnected
from the supply point. If connected via
a plug and socket, switch off at the
socket and withdraw the plug. Contact
the Service Department.
Do not reconnect the appliance to the
mains electricity supply until after it has
been repaired.
If there is any damage to the glass
surface the appliance must be
disconnected from the mains electricity
and gas supplies immediately and not
used until it has been repaired. Danger
of electric shock.
Repairs to the gas and electrical
components of this appliance must
only be carried out by a suitably
qualified person. Repairs and other
work by unqualified persons could be
very dangerous and could damage the
appliance. The manufacturer cannot be
held liable for unauthorised work. Never
open the housing of the appliance.
While the appliance is under
guarantee, repairs should only be
undertaken by a service technician
authorised by the manufacturer.
Otherwise the guarantee is invalidated.
Further safety notes
When using an electric socket near
the appliance, care should be
taken that the cable of the electrical
appliance does not come into contact
with the hot appliance. The insulation
on the cable could become damaged,
giving rise to an electric shock hazard.
Always ensure that food is
sufficiently cooked or reheated.
Many factors will affect the overall
cooking time, including the size and
amount of food and its temperature.
Some foods, e.g. poultry, may contain
micro-organisms which are only
destroyed by thorough cooking at a
sufficiently high temperature for long
enough. If in doubt, select a longer
cooking or reheating time.
Do not use plastic or aluminium foil
containers. These melt at high
temperatures and could catch fire.
Spray canisters, aerosols and other
inflammable substances must not
be stored in a drawer under the hob.
Cutlery inserts must be heat-resistant.
If the appliance has not been used
for a longer period of time it should
be thoroughly cleaned before it is used
again. It is also advisable to have the
appliance tested for safety. This should
be done at regular intervals.
The manufacturer cannot be held
liable for damage caused by
non-compliance with these Warning
and Safety instructions.
Warning and Safety instructions
11
Содержание KM 405
Страница 26: ...26 ...
Страница 27: ...27 ...
Страница 28: ...Alteration rights reserved 4406 M Nr 05 721 800 07 en ...