^
Pull bearing bush
c
downwards out
of hinge bracket
d
and refit it from
above into the hinge bracket.
^
Remove spacer
f
with a screwdriver
and refit it on the opposite side.
^
Remove plugs
j
from door bearing
bushes in the doors and refit on the
opposite side.
^
Unclip covers
m
at the front and slide
off to the side.
^
Unscrew handles
k
, and remove
stoppers
l
. Refit on the opposite
side of the door.
^
Slide covers
m
into position, making
sure they click into position correctly.
^
Fit the upper door in hinge pin
a
(re-
member to use the washers
b
) then
close the door.
^
Push middle hinge pin
e
from below
through hinge bracket
d
into the up-
per appliance door.
^
Check that the door is correctly
aligned. If necessary align it using
the long slots in hinge bracket
d
.
^
Hang the lower door in hinge bracket
d
then close the appliance door.
In the following illustration the lower
door is not shown in the closed posi-
tion to make it easier to see what
happens next.
^
Turn door support
b
around, pull
hinge pin
a
out, and refit on the op-
posite side.
^
Fit both parts into hinge plate
f
. To
do this push hinge pin
a
through
hinge plate
f
into door support
b
.
Swing door support out, push up-
wards and re-assemble with screw
c
.
^
Align the lower door using the long
slot in hinge plate
f
with the appli-
ance housing. Then tighten screw
c
.
^
Refit plinth facia
d
pushing it firmly
into position.
^
With the lower door open, secure
cover
e
to the front of the plinth fa-
cia.
Changing the door hinging
37
