![background image](http://html.mh-extra.com/html/miele/k-9552-id/k-9552-id_operating-and-installation-instructions_236487033.webp)
This appliance must be built in,
otherwise it could tip up.
Location
This appliance should be installed in a
dry, well-ventilated room. It should not be
installed where it is exposed to direct
sunlight or directly adjacent to a
heat-producing appliance such as an
oven or a radiator. The room temperature
should not go above or below the climate
range for which the appliance is
designed. The higher the ambient
temperature of the room, the more
energy the appliance requires to operate.
Important: tropical / humid
environments
During periods of high humidity,
some condensation may appear on
outside surfaces of cooling
appliances. This condensation will
disappear when humidity levels
drop. For prevention, it is advisable
to install the appliance with sufficient
ventilation in a dry and/or an
air-conditioned room. Please ensure
that doors are closing and sealing
properly. Please ensure that the
appliance is installed in accordance
with these installation instructions
and that the handle is fitted
correctly. Should you require further
assistance please contact your
Miele customer service centre.
Climate range
This appliance is designed for use
within certain climate ranges (ambient
temperatures), and should not be used
outside this range. The climate range of
the appliance is stated on the data
plate inside the appliance.
Climate range
Ambient room
temperature
SN
N
ST
T
+10°C to +32°C
+16°C to +32°C
+16°C to +38°C
+16°C to +43°C
Operating in a room which is too cold will
cause the cooling system to switch off for
too long, causing the internal temperature
in the appliance to rise with the risk of
food deteriorating and going off.
Ventilation
Air at the back of the appliance gets
warm. The appliance housing unit must
be constructed to allow sufficient space
for ventilation.
A ventilation gap of at least 38 mm
depth must be allowed for behind the
appliance for air to circulate.
The air inlet to the appliance is via the
plinth in the housing unit.
The cross-section of the air inlet and
outlet must be at least 200 cm
2
to
ensure that air can circulate without
hindrance. Otherwise the appliance has
to work harder, resulting in an increase
in electricity consumption.
The air vents must not be covered or
blocked in any way. They should be
dusted on a regular basis.
Installation
33
Содержание K 9552 iD
