Miele H 158 MB, Руководство по эксплуатации

Страница: 39 / 80

Automatic pre-selection
You can delay the switching on of the
appliance by up to 23 hours and 59
minutes after starting a process.
Set the time of day before using auto-
matic pre-selection (refer to “Setting
the time of day”). This makes the
start time easier to enter.
Enter the process required.
Every operating mode and pro-
gramme can be pre-selected.
Press the m touch control once be-
fore starting the process.
The text/symbol for “Start time” will light
up in the display area.
The time of day will appear in the dis-
play area.
Enter the start time you require using
the "+" touch control.
If you should press the "+" touch con-
trol for too long by mistake, use the " –"
touch control to correct the start time.
Begin the programme by pressing
the Start touch control.
The time of day will reappear in the dis-
play area. The text/symbol for “Start
time” will light up. The stored entries
will appear in the display area for se-
lected settings. If the automatic pre-se-
lection option in the Memory function
has been chosen, the entries for the
M1 Programme will be displayed.
Press the m touch control at any time
and the start time will reappear in the
display area.
This will light up for approx. 4 seconds
and will then be replaced by the time of
day.
When the door is closed the oven com-
partment light is not switched on during
the pre-selection time. You can switch
the oven compartment light on for a
short while by pressing the Enter touch
control. The oven light will go off again
automatically after approx. 10 seconds.
If you press the Stop/C touch con-
trol during the pre-selection time,
the most recently selected micro-
wave power setting will appear in
the display area. If the automatic
pre-selection option in the Memory
function has been chosen, the
microwave power setting for M1 Pro-
gramme will be displayed. All other
entries are now cancelled.
If the door is open at the start time
then the process will be stopped.
The most recently selected micro-
wave power output level will appear
in the display area.
Enter
Automatic pre-selection
39