Install the bracket on the rear of the
custom door panel
^
Push the dishwasher into its opening
and adjust the height.
^
Measure the distance
X
between the
round hole in the machine outer door
panel (shown in inset) and the lower
edge of the adjoining cabinet door.
^
Place the door panel on a flat
surface, good side face down, being
careful not to scratch the surface.
Make certain that the bottom of the
panel is towards you.
^
Using a pencil, lightly draw a vertical
centerline on the panel (See the
illustration on the next page).
^
Draw a horizontal line
X
inches up
from the bottom edge of the panel.
For two piece panels:
Two piece panels should be made so
that any joining hardware is flush with
the back of the panel. Failure to do this
may impede proper operation of the
dishwasher.
In certain instances, you may be able
to use the mounting bracket supplied
with the machine to secure both pieces
to the dishwasher. Consult your cabinet
supplier / maker for the best method of
joining the panels.
When mounting the two pieces,
make sure that the desired finished
panel height is maintained.
Installation
18
