Operation
78
Display of programme duration
The estimated duration of the selected
programme appears in the display
before the programme starts. During
the programme sequence, the time left
until the end of the programme and the
current programme stage are displayed.
The displayed duration may vary for the
same programme. It is influenced by,
for example, the temperature of the
incoming water, the reactivation cycle
of the water softener, the detergent
type, and the amount of dishes and
how soiled they are.
When a programme is selected for the
first time, the display will show the
average programme duration for a cold
water connection.
The programme durations shown in the
“Programme chart” refer to standard
test loads and temperatures.
Each time a programme is run, the
control module calculates the
programme duration depending on the
temperature of the water taken into the
dishwasher and the size of the load.
Starting a programme
If necessary, confirm the previously
displayed message with
OK
.
Touch the
Start
sensor.
The programme starts and the
message
Crockery can be added
appears.
As long as this message is showing,
crockery can be added without
compromising wash results.
Risk of scalding due to hot
water.
During operation, water in the
dishwasher may be very hot.
Only open the door if absolutely
necessary and exercise extreme
caution when doing so. Before
closing the door again, leave it ajar
for approx. 20 seconds. This will
enable the temperature in the wash
cabinet to settle.
Содержание G 7919
