Miele G 7804, Руководство по эксплуатации

Страница: 15 / 76

In order to achieve good cleaning
results, the machine needs to operate
with soft water. Hard water results in the
build-up of calcium deposits on the
load and inside the wash cabinet.
Mains water with a hardness level
higher than 0.7 mmol/l (4° dH – German
scale) needs to be softened. This takes
place automatically in the integrated
water softener.
– The water softener requires
reactivation salt.
– The machine must be programmed
to correspond to the water hardness
in your area.
– Your local water authority will be able
to advise you on the water hardness
in your area.
Where the water hardness fluctuates
e.g. between 1.4 - 3.1 mmol/l (8 -
17 °dH German scale), always
programme the washer-disinfector to
the higher value (17 °dH or 3.1 mmol/l
in this example).
The built-in water softener has
settings from 1 °dH - 60 °dH (0.2 -
10.8 mmol/l).
For future servicing it is useful to make
a note of your water hardness level.
Enter the water hardness below:
°dH
Programming the water
softener
^
Switch off the machine.
^
Turn the programme selector to
f
.
^
Press
4
and
6
at the same time,
hold them in and, whilst doing so,
switch the machine on with the
I-0
switch.
The current programme status P .... will
appear in the display.
The indicator light
p
/
6
will come on.
^
Press
3
once.
E01
will appear in the display.
^
Turn the programme selector one
switch position clockwise (1 o'clock
position).
The number 19 will appear in the
display (the factory water hardness
default setting in °dH, equivalent to 3.4
mmol/l).
^
Press
4
repeatedly as necessary, or
hold it in until the required value
(degree of hardness in °dH) appears
in the display.
See table on the next page for water
hardness settings in °dH, mmol/l and °f.
Once the number 60 has been
reached, the counter will begin again at
0
.
^
Press
6
.
SP
will appear in the display.
^
Press
6
again.
The setting will now be stored in
memory. The display will clear.
The machine is now ready for use.
Water softener
15