Rinse aid
For best results the rinse aid dosage
can be adjusted.
The dosage can be set between 0-6 ml.
The factory default dosage setting is
3 ml rinse aid.
The amount of rinse aid dispensed may
be more than the value set due to the
automatic adjustment of the "Sensor
Wash" program.
If spots appear on the dishes:
– Use a higher setting for rinse aid.
If smearing or streaking show:
– Use a lower setting for rinse aid.
^
Select the desired rinse aid amount
and confirm with the center button.
Optimize standby
A few minutes after the last key is
pressed or at the end of the program
the dishwasher will switch into Standby
mode to save energy. The display and
the indicators are turned off and only
the Start/Stop indicator light flashes
slowly.
If the dishwasher is not turned off after
the program ends, it will turn
completely off after a few minutes in
Standby mode.
This function can also be turned off.
The display and the indicators stay on
and the dishwasher will turn off after
approx. 6 hours.
^
Select the desired setting and press
the center button.
If refill salt and/or rinse aid or a fault
are present in the display, the
dishwasher will not turn off.
The refill messages can be turned
off when you use a tab detergent
(see "Settings-Refill indicators").
Fault messages cannot be turned
off.
Settings menu
42