Midway CRUIS'N USA, Руководство пользователя

Страница: 11 / 80

SERVICING
Always turn off power to game before servicing.
•
Control Panel
The control panel is held in place by two latches (located inside the cabinet, on the left
an right sides of the con'trol panel) which provide constant pressure on the strikes. The
latches can be reached th rough the coin door opening . Hold the control panel in place
and release the latches; lift the latch handle and unhook the wire fasteners. Carefully
lower the control panel until it rests on its support chains. To reinstall the control panel,
check for proper cable connection, including the ground strap. Raise it into position,
avoiding pinched wires. Re-clamp the latches.
•
Speakers
To access the speakers, remove five 1/4" hex-head wood screws holding the plastic
strip above marquee glass. Set strip aside and carefully lift glass. Store glass
carefully to prevent damage. It may be necassary to remove the fluorescent light
assembly to replace speakers. If so, disconnect the fluorescent light assembly from its
power cable. Remove the four hex-head screws fastening the assembly to the cabinet
and lift out.
•
Viewing Glass
The control panel is held in place by two latches (located inside the cabinet, on the left
an right sides of the control panel) which provide constant pressure on the strikes. The
latches can be reached through the coin door opening. Hold the control panel in place
and release the latches; lift the latch handle and unhook the wire fasteners. Carefully
lowe r the control panel until it rests on its support chains. Lift up on the viewing glass at
the bottom support ledge, then slide out.
•
Monitor Bezel
The control panel is held in place by two latches (located inside the cabinet, on the left
an right sides of the control panel) which provide constant pressure on the strikes. The
latches can be reached th rough the coin door opening. Hold the control panel in place
and release the latches; lift the latch handle and unhook the wire fasteners. Carefully
lower the control panel until it rests on its support chains. Lift up on the viewing glass at
the bottom support ledge, then slide out. Monitor bezel can now be easily accessed and
removed. Lift the bezel at the bottom support ledge, and slide out.
•
Marquee Glass
Remove five 1/4" hex-head wood screws holding the plastic strip above marquee glass.
Set strip aside and carefully lift glass. Store glass carefully to prevent damage.
•
Fluorescent Light Assembly
Remove five 1
/4"
hex-head wood screws holding the plastic strip above marquee glass.
Set strip aside and carefully lift glass. Store glass carefully to prevent damage.
Disconnect the fluorescent light assembly from its power cable. Remove the screws four
hex-head screws fastening the assembly to the cabinet and l ift out.
1-5