Midtronics MDX-P300, Руководство пользователя

Страница: 10 / 88

•
10
•
Battery Test Results
Decision Interpretation
GOOD BATTERY Return the battery to service.
GOOD-
RECHARGE Fully charge the battery and return it to
service.
CHARGE
& RETEST Fully charge the battery and retest. Failure
to fully charge the battery before retesting
may cause inaccurate results.
If CHARGE &
RETEST appears again after you fully charge the
battery, replace the battery.
REPLACE
BATTERY Replace the battery and retest. A REPLACE
BATTERY result may also mean a poor connection
between the battery cables and the battery. After
disconnecting the battery cables, retest the battery
using the out-of-vehicle test before replacing it.
BAD CELL-
REPLACE Replace the battery and retest.
If you have completed an out-of-vehicle test, the display alternates be-
tween the battery test results and the message PRESS
 FOR TO PRINT.
Because the printer is powered by the voltage of the battery you are test-
ing the battery voltage must be greater than 9 volts. Keep the clamps
connected and press
ENTER . For more information about the printer, see
“Changing the Printer Paper” on page 18 and “Troubleshooting the Print-
er” on page 19.
To quit before printing, disconnect the clamps. Remember to print out your
test results before the next test.
IMPORTANT: The MDX-P300 retains the results of the last test only. When
you start a new test, the last results are overwritten.
Starter System Test
If you have completed an in-vehicle test, the display alternates between
the battery test results and the message PRESS

FOR STARTER TEST.
To continue, start the engine at the prompt.
The display alternates between the decision on the starter system and the
measured voltage drop.