Midtronics MDX-652P, Инструкция по эксплуатации

Страница: 13 / 20

www.midtronics.com
MDX-652P
13
Test Messages
Test Message Interpretation
BAT. TEMPERATURE Select ambient temperature above or below 32 ºF (0 ºC)
CHARGE STATE Select before or after battery has been charged.
SURFACE CHARGE
DETECTED
Remove the surface charge before it begins testing. Testing will
resume after charge has been removed.
CHECK
CONNECTION
One or both clamps are not making proper contact with the
battery terminals.
ENGINE REV NOT
DETECTED PRESS

WHILE REVVING
Tester has not detected an increase in engine RPM.
REVERSE
CONNECTION
Clamps are connected in the wrong polarity:
positive to negative or negative to positive.
SYSTEM NOISE
CHECK LOADS
In-vehicle testing. Tester has detected computer, ignition noise
or parasitic drain. Make sure all vehicle loads are off including
open doors and ignition switch.
UNSTABLE
BATTERY
Out-of-vehicle. Weak battery, should be charged and retested.
WIGGLE
CLAMPS
Clamps are not making good contact with
battery terminals
Error Messages
Error Message Interpretation
BATTERY POWER TOO
LOW TO USE PRINTER.
CONNECT TO FULLY
CHARGED BATTERY
11.50 TO 16.00V
Battery being tested has fallen below 9 volts. Connect to
a fully charged battery to use the printer.
CONNECT TO
12V BATTERY
Tester is not connected to the battery
LOW INTERNAL AA
BATTERIES. REPLACE
AA BATTERIES SOON!
Internal AA batteries are low and need to be replaced.
See “Maintenance & Troubleshooting” section.
NON 12 VOLT SYSTEM
DETECTED
System being tested is not 12-volts.
PRINTER DOOR OPEN.
CLOSE DOOR AND TRY
TO PRINT AGAIN
Door covering printer paper is not secure.
PRINTER OUT OF PAPER
REPLACE WITH THERMAL
PRINTER PAPER.
2.5 IN. DIA. MAX.
2.25 IN. WIDE MAX
Printer is out of thermal paper. Replace with new roll.
See “Maintenance & Troubleshooting” section.
INVENTORY DATA
MEMORY FULL
PRINT RESULTS OR
CLEAR MEMORY.
INVENTORY mode memory is full. Select INVENTORY
mode from the Options Menu to clear the memory.