Midstream Modus 450, Руководство по установке, Страница: 2 / 7

midstreamlighting.com call +44 (0) 207 584 8310
2 3
MODUS 450 INSTALLATION GUIDANCE V1
Contents
Prior to starting the installation, check the equipment list
to be sure of using the correct tools
DO NOT USE PERCUSSION DRILLS!

30 mm standard wrench for M20 screws

21 mm standard wrench for connector cables

19 mm standard wrench for M12 screws

#8 allen key

#6 allen key

Powered drill-screwdriver with adjustable torque
(clutch)

Torx T30 insert bit for powered screwdriver (to be
used with M6 screws)

Torx T30 manual screwdriver

Monkey pliers

Electrician scissors for wires

Slotted manual screwdriver for connector’s screws
(blade dimensions: 3.5(w) x 0.6 mm)
Equipment list

Wear adequate working gloves, safety shoes and
hard hats to protect yourself from falling material

Never energize the lamp if wiring operation is not
completed
H&S check
1. General notes
Section PAGE
1 General notes 3
2 Safety instructions 4
3 Contents 5
4 Bracket mounting and aiming 6
5 Visor mounting 7
6 Electrical connection 7
7 Electrical specifications 10
8 Weight and Windage 10
9 Dimensions 11
This user manual contains important information on safe operation of the Luminaire.
Read and follow all safety notes and all instructions. Save this manual for future reference.
Make sure that it is available to all persons using this device.
All wiring should be done by a licensed electrician in accordance with state codes, local codes, and National Electric
Code (NEC) standards or International Electrotechnical Commission (IEC) standards.
The Luminaire is suitable for out door use and wet locations.
This luminaire must only be replaced by the manufacturer, by its service staff or by qualified personnel.
IP66: The product is protected against powerful water jets.
DO

Store the luminaire with care, avoiding placing the lenses on the ground, which may scratch or damage them

Keep the luminaire in the original packaging when storing to avoid damage

When handling the Luminaire, wear industrial safety gloves and safety boots

Operate on circuitry when the electrical power supply is disconnected
DO NOT

Do not apply mains voltage through the control system cable. This will damage the luminaire and it will no longer
be covered by warranty

Do not unnecessarily remove the luminaire from the box

Do not leave the LED luminaire switched on when resting on the ground with optics facing down

Do not place the luminaire with the lens on the ground, dirty or metal surfaces

Do not clean the lenses with any industrial detergent. Only use a water-soaked cloth if needed