Midland XTC 450, Инструкция по эксплуатации

Страница: 19 / 117

UK
Midland XTC450 - 17
Mounting and Aiming Your Camera
Mount on Dual Track System
The XTC450 was designed with an innovative 3 point
mount system on both sides and the bottom of the camera.
This allows you to mount it on any side with ease.
To mount the camera on the basic mount, slide the camera
onto the track system with the notches on the mount fa-
cing toward the back of the camera.
To detach the camera from the mount, squeeze the mount
release tabs and slide the camera forward.
Aiming the Camera when mounted with the dual track
mount:
When mounting the camera on a helmet, you must do the
following:
1. Consider what you would like to shoot and mount the
camera accordingly- left side, right side or top.
2. Find an appropriate surface and ensure the area is clean
of dirt and debris.Remove the cover of the adhesive pad
and adhere to the helmet.
3. Once attached, adjust the camera to be sure you are fil-
ming in the intended direction
4. If needed, rotate the lens to maintain an upright viewing
angle
5. To see where your camera is aimed, enable Wi-Fi and use
your smartphone with the app as a viewfinder.
Mounting and Aiming Your Camera
Mount using the Thread Mount
On the bottom of the XTC450 is a standard thread mount
that allows the camera to be mounted to a tripod or other
fixture with a 1/4-20 (1/4” diameter, 20 threads per inch)
5/16 deep thread. To attach the camera, insert the screw on
the mount into the camera thread and rotate the camera
clockwise to tighten down onto the screw.
Note: Over tightening may cause damage to the mount and/
or camera
Tripod Mount