V0.2
5. Technical Data
Inputs
INPUT 1-4
Jack ¼” (6.35 mm) socket
line mode: High impedance, balanced input for instruments (pick-ups) and line-level
sources Jack socket only
Sensitivity: 15 mV (–36 dBV) Impedance: 1 KΩ
Equivalent input noise, A-weighted: 2.5 uV (–112 dBV)
Tone controls
Bass
± 8 dB at 100 Hz, shelf type
Middle
± 6 dB at 800 Hz
Treble
± 8 dB at 10 kHz, shelf type
Power
Power amp
50 W / 8 Ω, DMOS, monolithic I.C. Dynamic range, A-weighted: 92 dB (note 2).
Analog signal processing
Dedicated equalizer, subsonic filter, adaptive peak limiter
Speaker system
10” (50 W / 8Ω)bass speaker, 2.5” (20 W / 8Ω)tweeter speaker reflex enclosure
Mains power
Mains voltage (depending on model): 100, 120, 230, or 240 V AC, 50–60 Hz.Power
consumption: max. 100 W
Mains fuse
5x20 mm Slow 1 A for 230 and 240 V models Slow 2 A for 100 and 120 V models
General
Cabinet
15 mm (0.58”) finish birch plywood
Finish
Water based acrylic, black spatter finish
Dimensions
360 mm , high 350 mm ,wide 358.5 mm
Weight
12.08 kg
Notes:
1. Input sensitivity
Input sensitivities refer to 35 watts into 4 ohms, full gain and master settings, neutral tone control settings, and 1 kHz
sine-wave test signal.
2. Noise and dynamic range
Equivalent input noise voltage was obtained by measuring noise voltage at speaker output and dividing by the effective
voltage gain of the amplifier. Full gain and master settings, neutral tone control settings, input shorted, measuring
bandwidth 20 Hz – 20 kHz.
Dynamic range of power amplifier: Range between output signal at limiter threshold and A-weighted output noise with
master volume in zero position.
Specifications and appearance subject to change without notice.
Owner’s Manual
PM110
Professional Percussion Monitor Speaker
