Midian VS-1000- KW1, Руководство по установке

Страница: 5 / 20

5
PRODUCT PROGRAMMING
Note: Greater details of the VS series products can be found in the VS Series Technical Reference Manual.
Midian’s VS-1xxx-KW1 is programmed via Midian’s KL-4 programmer. Please reference the KL-4 manual for
setup instructions of the programming software and hardware. From the product selection screen on the
programming software, select the VS-1xxx from the list and click OK.
Set the parameters of the scrambler software to fit the application. If any clarifications on a feature are required,
move the mouse cursor over the feature name until the question mark appears and right click, a definition of the
feature will be shown.
After entering the parameters, save the file by going to File - Save As. Enter the file name in the File Name block
and click Save. Saving the file will allow for quick and easy reprogramming of units.
Programming: Plug the board onto the KL-4. Push the power button on the KL-4 and click “Program Unit” in the
programming software. The LED on the KL-4 will faintly flash if programmed successfully.
Reading: Plug the board onto the KL-4. Push the power button on the KL-4 and click “Read Unit” in the
programming software.
Note: The security pass phrases can use any 8-bit ASCII keyboard characters. These include the characters on a
typical English keyboard such as 0-9, A-Z (upper and lower case), *, #, @, $, etc. Spaces are also allowed.
Midian does not recommend using international language character such as ñ, ä, ß, ü, é, etc. as these have not
been tested. Please also note that the pass phrases are case sensitive.
Important Note: Do not attempt to ‘clone’ the scrambler by reading one and then programming another. When
the scrambler is read, the pass phrases will be read out as “<undefined>”. If another scrambler is then cloned
with this information, the scramblers will be incompatible because they have different pass phrases. To ensure
scramblers communicate with each other, program them from a saved
file.