Midian Electronics KL-4F, Руководство пользователя

Страница: 8 / 16

8
CONTROLS & INDICATORS
Ready LED:
When illuminated this LED indicates that the KL-4F is receiving power from the USB.
Power Button: Press this button when ready to program to send power to the module to be programmed.
Power Jumper (JP4):
If the jumper is in the 1-2 position, the power button is a momentary switch. If the jumper is
in the 2-3 position the power button is a latched switch. If set for momentary, the power button must be pressed
and held during programming.
Power LED:
When illuminated this LED indicates that the KL-4F is providing power to the module to be
programmed.
PTT Buttons: The following products must have either the +PTT button or –PTT button pressed and held before
pressing and holding the power button to put the unit in program mode upon power up.
AE-1, ANI-F, BTD-2, ID-1, PR-1, RD-1, RM-1, RT-2, TDS-1, TDS-3, UD-1B, UE-1, UED-1B, UED-1B-BEZEL
Use the +PTT button if the unit is programmed to a positive PTT. Use the –PTT button if the unit is programmed
to a negative PTT. Midian’s products are shipped from the factory programmed for negative PTT.
PTT LED: When illuminated this LED indicates that the PTT button is pressed and the KL-4F is giving an active
PTT to the module to be programmed.
RM-1 Jumper (JP2): For all products being programmed on the P5 connector, this jumper should be in the 2-3
position. However, if programming the RM-1 put this jumper in the 1-2 position.
ACK LED: You will receive a visual pulsing verification of successful programming on LED D6 depending on the
product. This is not available on all products.
TXD LED:
This LED will flash when the KL-4F is transmitting data to the module to be programmed.
RXD LED: This LED will flash when the KL-4F is receiving data from the module to be read.
-PTT Button
+PTT Button
RM-1 Jumper
Ready LED
ACK LED RXD LED
Power Button
TXD LED
Power LED
PTT LED
Power Jumper