1
Technical Service Guide
Compact Dishwasher
（
6 settings
）
MODEL SERIES:
WQP6-3602E
IMPORTANT SAFETY NOTICE
The information in this service guide is intended for use by individuals possessing adequate backgrounds of
electrical, electronic, and mechanical experience. Any attempt to repair a major appliance may result in personal
injury and property damage. The manufacturer or seller cannot be responsible for the interpretation of this
information, nor can it assume any liability in connection with its use.
WARNING
To avoid personal injury, disconnect power before servicing this product. If electrical power is required for diagnosis
or test purposes, disconnect the power immediately after performing the necessary checks.
RECONNECT ALL GROUNDING DEVICES
If grounding wires, screws, straps, clips, nuts, or washers used to complete a path to ground are removed for
service, they must be returned to their original position and properly fastened.
MIDEA
C
ONSUMER
P
RODUCTS
T
ECHNICAL
S
ERVICE
G
UIDE
COPYRIGHT.
2014
A
LL RIGHTS RESERVED
.
T
HIS SERVICE GUIDE MAY NOT BE REPRODUCED IN WHOLE OR IN PART
,
IN ANY FORM
,
WITHOUT
WRITTEN PERMISSION FROM THE MIDEA DISHWASHER MANUFACTURING
C
OMPANY
.
CONTENTS
Introduction
............................................................................................................................................................. 3
Specification
........................................................................................................................................................... 3
Control Panel Features
......................................................................................................................................... 3
Component Locator Views
................................................................................................................................... 4
Dishwasher Components
..................................................................................................................................... 5
Main control board
......................................................................................................................................... 6
Floater assembly
........................................................................................................................................... 7
Heating pump motor assembly
.................................................................................................................... 7
Heating pump assembly
............................................................................................................................... 8
Motor assembly
.............................................................................................................................................. 9
Drain pump assembly
................................................................................................................................. 10
Check plate
................................................................................................................................................... 11
Inlet valve
...................................................................................................................................................... 11
Control panel
................................................................................................................................................ 12
