Key " ": cancel,
return, exit and
delete.
Reminder
Slightly upward
Slightly downward
Slightly leftward
Slightly rightward
Operation and Management
Electricity consumption check
Home leaving mode
Fingerprint registration
Doorbell
Emergency power
Battery Input
• After locking, wake up the screen, and it prompts "keypad locked"; verify the fingerprint, and
it prompts "fingerprint locked"; and verify the card, it prompts "card locked".
Digital Keypad
Touch the low-battery alarm key on the digital keypad to check the real-time
electricity consumption.
Some users, such as the elderly and children, are prone to fingerprint recognition failure after entering their
fingerprints. The following methods can be used to improve the recognition rate (you may also unlock by
password or RF card):
• Make sure the fingers are clean before inputting the fingerprint.
• Input the fingerprint of the same finger successfully for several times
• Keep the fingers dry as wet fingers may affect the accuracy of recognition.
• To ensure effective unlocking, clean up the fingerprint input area when scanning a
fingerprint. If the fingerprint input area is damaged, stop using it and contact the customer service hotline
for repair.
• Only use 2A batteries that meet national safety standards. The positive and negative poles should be
installed correctly;
• If the Lock will not be used for a long time, remove the batteries;
• Old and new batteries must not be mixed using together.
• Comply with local environmental protection laws to dispose the used batteries;
• If your skin or clothes come into contact with battery fluid, rinse with water immediately. If the fluid gets in
your eyes, rinse your eyes with water immediately and seek for medical treatment afterwards.
When the battery is too low to open the Lock, use the emergency power interface
(micro USB, 5 V) to connect the mobile power to unlock the door. Replace all
batteries immediately after unlocking.
Remove the battery cover
,
insert eight 2A batteries into the battery compartment
and install the battery cover.
When the user unlocks the door inside with the door opening button, the digital key
lights up when the door is closed and locked again. At this time, touch the key to
enter the home leaving mode.
Please enter your fingerprints in a relax and comfortable handle
holding posture.
Place a finger steadily on the center of the fingerprint input area according
to the voice prompt.
Slightly move your finger up, down, left and right according to the figure
below. Before placing the finger each time, lift the finger first and then
put it down again until the voice prompts confirmed that the fingerprint is
registered successfully.
Press the doorbell button and the door lock will give a "ding-dong" sound.
Alarm function
1
Demolition alarm
When the lock is forcibly removed, the alarm sound of the lock will continue until the
batteries are removed or fully consumed.
2
Keypad lock
• Accumulate the number of incorrect unlocking: for example, if the password is
entered incorrectly twice while the wrong fingerprint is input for 3 times, the cumulative
incorrect input is 5 times;
• When the cumulative number of wrong unlocking reaches 5 or above, all the
unlocking methods will suspended. At this time, only a mechanical key can be used
to unlock the door;
• After all unlocking methods are locked, wait for 90 seconds and the door can be
unlocked by using proper unlocking method.
3
Low-battery alarm
When the power is low, the lock will send a voice prompt every time the door is
opened. In this case, replace the batteries.
Low-battery alarm
Electricity
consumption inquiry
Key "0-9": Digital input keys.
Key " ": Confirm and finish.
Mute the unlocking sound once
Reminder
Note
P
ro
d
u
c
t
O
ver
v
ie
w
Operation
Installation
Maintenance
Appendices
P
ro
d
u
c
t
O
ver
v
ie
w
Operation
Installation
Maintenance
Appendices
Содержание MLPBF510D21
Страница 10: ...2021 10 25 V F...