The wash stops
Programme selection
1
Install the washing
machine
3
measure out the
detergent
7
Plug the power supply
6
Turn on the water tap
8
Select the desired
programme
5
Put down (hang up)
the drain pipe
4
Close the
machine door
9
Press the
[start/pause] key
11
When the wash stops,
the buzzer will buzz continuously for 6 times and
then the power will be automatically cut off.
Turn off the water tap
.
Although the power can be cut off automatically, the power plug must be pull
out for the safety.
1
Press the POWER button.
3
Press the start/pause key.
2
Select the proper water level and other attached functions
.
2
Load the laundry
12
Quick start
The main wash
1.Close the lid of the door when machine is running, otherwise, it will automatically
stop working during spin process and send out abnormal warning.
2.The washer will not work when the filled water does not reach the set water level.
3.The selection of rinse water level: the level is equal to wash water level.
Press [Rinse Level] button, the indicator light which stand for rinse level flickered.
User can select the rinse water level according to needs. Rinse level exceed that
wash level all the time. It shows the wash level if not press this button. And only
show rinse level when rinseing.
4.After pressing down [ Power Switch ], if the [Start / Pause ] button is not pressed,
the power will be automatically cut off in 10 minutes.
NOTICE
！
Instruction of the NORMAL program
Instruction to single wash procedure
Steps in details
1.Press the power switch.
2.According to the washing amount choose the proper water level.
3.Press START/PAUSE button.
1.[Normal] wash program is the easiest, most convenient and most common washing
program. When the user press the power switch and then press [Start/Pause] button,
the normal washing program will start to work.
2.When the washer start to work, the digital tube show the remain time. The indicator
light which stand for remaining time is flickering.
1.User may freely select any single procedure, or any combination of procedures
among WASH, RINSE and SPIN according to the actual requirements. It is only
required to turn off any one or two of these three indicators that not needed by the
user. And keep the indicator be on showing the process needed by the user.
2.Single wash -- after switching on the power, turn off RINSE and SPIN two indicators
by pressing these two keys. The operation for single rinse and single spin is similar.
3.Single wash-spin – after switching on the power, turn off RINSE indicator by pressing
that key. The operation for single rinse-spin and single wash-rinse is similar.
