Midea MFA-12HRDN1-Q Скачать руководство пользователя

Страница: 4 / 22

installation & owner’s manual

Wiring routing must be properly arranged so that control
board cover is fixed properly.

If control board cover is not fixed perfectly, it will cause
heat-up at connection point of terminal, fire or electrical
shock.

If the supply cord is damaged, it must be replaced by the
manufacture or its service agent or similarly qualifued
person in order to avoid a hazard.

An all-pole disconnection swith having a contact
separation of at least 3mm in all poles should be
connected in fixed wiring.

When carrying out piping connection, take care not to let
air substances go into refrigeration cycle.

Otherwise, it will cause lower capacity, abnormal high
pressure in the refrigeration cycle, explosion and injury.

Do not modify the length of the power supply cord or use
of extension cord, and do not share the single outlet with
other electrical appliances.

Otherwise, it will cause fire or electrical shock.

Carry out the specified installation work after taking into
account strong winds, typhoons or earthquakes.

Improper installation work may result in the equipment falling
and causing accidents.

If the refrigerant leaks during installation, ventilate the
area immediately.

Toxic gas may be produced if the refrigerant comes into the
place contacting with fire.

The temperature of refrigerant circuit will be high, please
keep the interconnection cable away from the copper
tube.

After completing the installation work, check that the
refrigerant does not leak.

Toxic gas may be produced if the refrigerant leaks into the
room and comes into contact with a source of fire, such as a
fan heater, stove or cooker.

To install properly, please read this "installation manual" at
first.

The air conditioner must be installed by qualified persons.

When installing the indoor unit or its tubing, please follow
this manual as strictly as possible.

If the air conditioner is installed on a metal part of the
building, it must be electrically insulated according to the
relevant standards to electrical appliances.

When all the installation work is finished, please turn on
the power only after a thorough check.

Regret for no further announcement if there is any change
of this manual caused by product improvement.

2. INSTALLATION INFORMATION

Ground the air conditioner.

Do not connect the ground wire to gas or water pipes,
lightning rod or a telephone ground wire.Incomplete
grounding may result in electric shocks.

Be sure to install an earth leakage breaker.

Failure to install an earth leakage breaker may result in
electric shocks.

Connect the outdoor unit wires , then connect the indoor
unit wires.

You are not allow to connect the air conditioner with the
power source until wiring and piping the air conditioner is
done.

While  following  the  instructions  in  this  installation
manual,  install  drain  piping  in  order  to  ensure  proper
drainage  and  insulate  piping  in  order  to  prevent
condensation.

Improper drain piping may result in water leakage and
property damage.

Install the indoor and outdoor units, power supply wiring
and connecting wires at least 1 meter away from
televisions or radios in order to prevent image
interference or noise.

Depending on the radio waves, a distance of 1 meter may not
be sufficient enough to eliminate the noise.

The appliance is not intended for use by young children
or infirm persons without supervision.

Don't install the air conditioner in the following locations:

There is petrolatum existing.

There is salty air surrounding (near the coast).

There is caustic gas (the sulfide, for example) existing

in the air (near a hot spring).

The Volt vibrates violently (in the factories).

In buses or cabinets.

In kitchen where it is full of oil gas.

There is strong electromagnetic wave existing.

There are inflammable materials or gas.