6
3-3 The display panel is shown as below:
From the left to right: Powr, Heating, Cooling, Supplying Water
1. Requirem ents on Functions
1.1. Supply Power
After LED lights on from left to right(1s for every LED), power LED indicator lights on.
1.2. Heating Icon
The heating icon lights on when heating, and it lights off after heating or don’t heating.
1.3. Cooling Icon
The cooling icon lights on when cooling, and it lights off after cooling or don’t cooling.
1.4. Water Shortate Icon
When there isn’t water, the water shortage icon flashes, when there’s water, the icon
lights off.
3-2 Machine Installation
WARNING!
To avoid a hazard due to instability of the appliance, it must be fixed in accordance
with the instructions.
Water dispenser
Bracket
The hole for
tighten screw
1-2. Loosen the screw of the left or right bottom angle
just as the picture shown.
3. Use the screw to fix the bracket on the left or right
bottom angle of the water dispenser.
4. Make a hole on the floor’s or the desk’s surface where
the water dispenser will be installed.
5. Fix the bracket on the floor by screw tightly.
6. Tighten the screw.
5
6
3-4. Filter Replacement Cycle
(approximately
6 months)
(approximately
6 months)
(approximately
12 months)
(approximately
18 months)
PP fibre filter Front active carbon filter Post active carbon filter
UF membrane filter
Special hints:
The data above are for references only. It is based on 10L per daily drinking water.
The specific cycle for replacement of filters varies with local water quality and water amount
consumed.
