6
3.4 Plumbing Connection
②
③
NOTE
The film exists respectively at the two side of the upper enclosure. A user can get rid of
one film according to the indicated arrows by scissors.
NOTE
Remove the film at the power cord’s entrance on the opposite of the upper enclosure and
connect the approved power cord to the corresonding holes in the terminal block. When install
the plug wire, you should fix the safety swith, in circuitry. There is more than 3mm distance
between the two poles when turn off the safety switch.
Select the electric cable entry place. If necessary, cut the thin wall on the enclosure in the
proper place using a knife.
④
④
Selection the water heater installation place. (See Fig.3)
①
②
Connect the hose into the water inlet and ensure that no leakage exists. The water heater
is an open-outlet water heater; please ensure there is no valve or the like in the outlet pipe.
（
See Fig.4)
Fix the bottom enclosure on the wall by tightening the three screws. The water heater should be
placed horizontally. The water inlet and outlet should be centripetal.
NOTE
Blue marker stands for water inlet, red marker stands for water outlet. Do not overexert
to avoid damaging the water heater.
(Fig.3)
Kitchen
Shower
Bathroom
Install the appliance on the wall horizontally with its connections strictly downward securing it
with screws from the set of installation fixtures included by the manufacturer to the package.
The water heater for bath is fixed on the wall at a height more than a person’s height.
When using the water heater, be care not to let water splash on it.
