32801000302
23
Specifications subject to change without notice.
WIRELESS REMOTE CONTROL INSTALLATION
Mounting Bracket (if installed on the wall)
1. Use the two screws supplied with control to attach the mounting bracket to the wall in a location selected by customer and within operating
range.
2. Install batteries in the remote control.
3. Place the remote control into the remote control mounting bracket.
4. For remote control operation, refer to the unit owner’s manual.
NOTE: If a wireless remote controller is used, relocate the IR receiver within line of sight of remote location using the 6 ft. cable included. The
factory location of the IR receiver is inside the control box (see Fig. 48).
A150642
Fig. 48
-
Control Box
WIRED REMOTE CONTROLLER INSTALLATION
To connect the wired remote controller (7 Day Programmable KSACN0501AAA) to the indoor unit, use 4−pin connector CN40 located on the control
board.
To connect the wired remote controller (Timer Function KSACN0101AAA) to the indoor unit, use 5−core shielded cable and 5−pin connector from
IR receiver located in the control box (see Fig 48).
For setup instructions, refer to the controller installation manual.
