Service manual for Dryer Machine
-------------------------------------------------------------------------------------------------------------------------------------------------------
－
19
－
All gas installations must be done in accordance with the National Fuel Code ANSI/Z2231 -
Latest Revision (for the U.S.) or CAN/CGA - B149 Installation Codes - Latest Revision (for
Canada) and local codes and ordinances.
Installation Steps
For the proper installation, we recommend that you hire a qualified installer.
1. Move your dryer to an appropriate location for the
installation. Consider installing the dryer and washer
side-by-side, to allow access to the gas, electrical, and
exhaust connections. Place two of the carton
cushion-tops on the floor. Tip your dryer on its side so
it lies across both cushion-tops.
2. Set your dryer back in an upright position.
3. To ensure that the dryer provides the optimal drying
performance, it must be leveled. To minimize vibration,
noise, and unwanted movement, the floor must be a
perfectly level, solid surface.
- Adjust the leveling feet only as much as necessary to level the dryer. Extending the leveling
feet more than necessary can cause the dryer to vibrate.
4.
Review the “Exhausting” section on page 10 before installing the exhaust system. Install the
ductwork from your dryer to the exhaust hood. The crimped end of the duct sections must
point away from your dryer.
DO NOT use sheet metal screws when assembling the ducting. These joints should be taped.
Never use plastic flexible exhaust material.
Tip for tight installations: install a section of the exhaust system onto your dryer before putting
it in place.
Use duct tape to secure this section to your dryer, but do not cover the ventilation slots at the
back of the unit in dryer cabinet.
