Middleby Marshall PS360E Series, Руководство владельца по эксплуатации и установке

Страница: 40 / 60

SECTION 4
MAINTENANCE
40
Cooling Vents and Grills
II. MAINTENANCE - MONTHLY
NOTE: When removing the conveyor, refer to Figure
21 (in Section 2, Installation).
1. Check that the oven is cool and the power is
disconnected, as described in the warning at the
beginning of this section.
2. Remove the crumb trays from the oven.
3. Lift the drive end of the conveyor slightly, and push
it forward into the oven. This removes the tension
from the drive chain. Then, remove the drive chain
from the conveyor sprocket.
4. Slide the conveyor out of the oven, folding it as it
is removed.
5. Remove the end plugs from the oven. The end
plugs are shown in Figure 2 (in Section 1,
Description).
6. Slide the air fingers and blank plates out of the
oven, as shown in Figure 31. AS EACH FINGER
OR PLATE IS REMOVED, WRITE A “LOCATION
CODE” ON IT WITH A MARKER to make sure that
it can be reinstalled correctly.
Example of markings:
(Top Row)
T1 T2 T3 T4
(Bottom Row) B1 B2 B3 B4
Removing Air Fingers and Plates
7. Disassemble the air fingers as shown in Figure 32.
AS EACH FINGER IS DISASSEMBLED, WRITE
THE “LOCATION CODE” FOR THE FINGER ON
ALL THREE OF ITS PIECES. This will help you in
correctly reassembling the air fingers.
NOTICE
Incorrect reassembly of the air fingers will change the
baking properties of the oven.
Disassembling the Air Fingers