Middle Atlantic Forward BGR, Инструкция

Страница: 3 / 6

Page 3
INSTALLING FORWARD BGR RACKRAILS INTO RACKRAIL BRACKET SLOT OPENINGS
NOTE :
• Exact installation position of rackrails along the rackrail
brackets may vary based on your specific power and
cabling setup.
• Install your rackrails in line with any existing rackrails already in your
enclosure.
1. Line up one of your rackrails (A) against the rackrail bracket slot
openings inside of your enclosure to determine which of the larger
holes on the rackrail will be used for your hardware (hex head bolts
and rackrail nuts).
2. Put a hex head bolt (B) through a larger hole in the top location (determined from the previous step)
on one of your rackrails (A) and thread the bolt (approximately 2 - 3 full turns) into a rackrail nut (C).
(
FIGURE B
)
3. Insert the rackrail nut (partially assembled to the rackrail via the hex head bolt from the previous step)
through a nearby slot opening in your desired location along the rackrail bracket. ( FIGURE C )
4. Repeat the previous steps to match the hardware amounts (hex head bolts and rackrail nuts) to the
amount of rackrail brackets in your enclosure.
TIP : Work from the top rackrail bracket down.
5. Now, repeat the previous steps using the other piece of rackrail and hardware on the other side of your
enclosure’s interior.
6. Position your rackrails evenly in your desired location along the rackrail brackets.
7. Use a 7/16” wrench to tighten all bolts.
FIGURE A
Isolated rackrail bracket from a
BGR with slot openings left black
for clarity. (
FIGURE A
)
NOTE :
Hand-tighten
the bolt at this
point to allow for
adjustments.
A
B C
FIGURE B
C
A
B
FIGURE C
Insert rackrail nut
through slot opening.
Slot opening along
rackrail bracket.
NOTE : View from
inside of enclosure.