Chapter 1: Introduction
17
Reset Button
The reset button is located inside the small hole above the the label on the PDU.
The PDU can be reset to its factory default values using this button when a serial connection is available. See
(on page 204).
Without the serial connection, pressing this reset button restarts the PDU's software without any loss of power to outlets.
The following image illustrates the location of the reset button.
Circuit Breakers
The circuit breakers automatically trip (disconnect power) when the current flowing through the circuit breaker exceeds its
rating.
When a circuit breaker trips, power flow ceases to all outlets connected to it. You must manually reset the circuit breaker so
that affected outlets can resume normal operation.
Resetting the Circuit Breaker
To reset the breaker:
1.
Locate the breaker on the unit as shown.
Rackmount PDU
Circuit Breaker
