
Chapter 3: Using the Web Interface
152
Placeholder
Definition
[SENSORSTATENAME]
The human readable state of a sensor
[SMTPRECIPIENTS]
The list of recipients, an SMTP message was sent to
[SMTPSERVER]
The name or IP address of an SMTP server
[SYSCONTACT]
SysContact as configured for SNMP
[SYSLOCATION]
SysLocation as configured for SNMP
[SYSNAME]
SysName as configured for SNMP
[TIMEREVENTID]
The id of a timer event
[TIMESTAMP]
The timestamp of the event occurrence
[TRANSFERSWITCHREASON]
The transfer reason
[TRANSFERSWITCHSENSOR]
The transfer switch sensor name
[TRANSFERSWITCH]
The transfer switch label
[UMTARGETROLE]
The name of a user management role, an action was applied on
[UMTARGETUSER]
The user, an action was triggered for
[USERIP]
The IP address, a user connected from
[USERNAME]
The user who triggered an action
[VERSION]
The firmware version the device is upgrading to
[SURGESTATUS]
Surge protection status
Editing or Deleting a Rule/Action
You can change the settings of an event rule, action or scheduled action, or delete them.
Exception: Some settings of the built-in event rules or actions are not user-configurable. Besides, you cannot delete built-in
rules and actions. See Built-in Rules and Rule Configuration (on page 120) or Available Actions (on page 131).
To edit or delete an event rule, action or scheduled action:
1.
Choose Device Settings > Event Rules.
2.
Click the desired one in the list of rules, actions or scheduled actions. Its setup page opens.
3.
Perform the desired action.