Microtronics myDatalogGauge 3G, Руководство пользователя

Страница: 76 / 158

Operation by the user Device response Operation after releasing the reed switch
Press briefly (approx. one
second) Display is activated for 20sec. Displaying of the information about the installed
software followed by displaying the current
operating state (see "Display" on page 76)
Press and hold for three
seconds Setup mode is activated ---
The display of the myDatalogGauge 3G is activated as soon as the reed switch is pressed. The time for which
the reed switch was pressed is visualised by a circle in which the segments change from white to green.
Setup mode is activated once all of the segments have switched from white to green, i.e. the reed switch has
been pressed for at least three seconds (see "Setup mode" on page 41).
... ...
Visualisation of the time for which the reed switch was pressed
10.1.1.2 Display
Important note:
l
Do not touch the display with a sharp object, such as the tip of a pen.
l
Do not stand or place any objects on the display as this could scratch it.
The display of the myDatalogGauge 3G is only designed to show the current measurement values (fill level
and temperature) and various status information. The device cannot be operated via the display. The display
is activated by briefly holding the magnet (approx. 1 sec.) to the reed switch (see "Reed switch" on page 75)
or by inserting the activation module (see "Inserting the activation module" on page 61). The display then
remains active for 20sec. , first showing information about the installed software for 3sec. and then the
current operating state.
Display of the information regarding the installed software
1 Brief designation of the IoT application installed
on the device 3 Current software version installed on the
measurement controller
2 Version number of the IoT application that is
currently installed on the device
76 Rev. 01