Microtronics myDatalogEASY IoTmini, Руководство пользователя

Страница: 67 / 210

Chapter 8 Initial Start-Up
Chapter 8 Initial Start-Up
8.1 User information
Before you connect the myDatalogEASY IoTmini and place it into operation, you must observe and comply
with the following user information!
This manual contains all information that is required for using the device.
Is intended for technically qualified personnel who have the relevant knowledge and experience in the area of
measurement technology.
Read this manual carefully and completely in order to ensure the proper functioning of the
myDatalogEASY IoTmini .
Contact Microtronics Engineering GmbH(see "Contact information" on page 209) if anything is unclear or if
you encounter difficulties with regard to installation, connection or configuration.
8.2 Applicable documents
In addition to this operating instructions, additional instructions or technical descriptions may be required for
the installation, commissioning and operation of the entire system.
These instructions are enclosed to the respective additional devices or sensors or are available for download
on the Microtronics website.
8.3 General principles
The entire measurement system may only be placed into operation after completion and inspection of the
installation. Study the manual thoroughly before placing into operation to prevent faulty or incorrect
configuration.
Utilise the manual to familiarise yourself with the operation of the myDatalogEASY IoTmini and the input
screens of the myDatanet server before you begin with the configuration.
8.4 Commissioning the system
Note: It is recommended that the myDatalogEASY IoTmini is first placed into operation in the office before
mounting the device permanently at the place of use. During this process, you should create a site for the later
operation on the myDatanet server (see "Creating the site" on page 81) and determine a site configuration
(including Data Descriptor and Device Logic) (see "Site configuration" on page 72). If you create the site based
on an IoT application (see "myDatanet Server Manual " 805002), the Data Descriptor and Device Logic are
taken from the IoT application and do not need to be defined separately. Take the opportunity to get to know the
functions of the device in a stable environment. You can also use suitable test signals to simulate the sensors
to establish the optimum configuration of the myDatalogEASY IoTmini prior to its actual first use. This reduces
the amount of time required for on-site installation to a minimum.
Rev. 01 67