28
Press-in threaded M4 Stud Method
The studs should be pressed into the back of the panel. The brackets slip onto the studs using
the through-holes in the brackets. Nuts (not included/customer supplied) secure the brackets
to the back of the panel.
Threaded M4 holes in thick panel method
Holes are drilled into the back of the panel, stopping short of the panel front to preserve
invisibility. The holes should be tapped for M4 screws. Customer-provided M4 screws of the
proper length go through the through-holes in the bracket, then screw into the threaded holes
in the panel. The spacing is the same as for pressed-in studs.
M4 Through-hole method
Countersunk holes are drilled into the front of the panel. Customer-provided flat head M4
screws pass through the front of the panel and thread into the tapped holes in the panel bracket .
The heads of the screws will be visible on the front of the panel, but the screw heads will be
flush with the panel if the holes are properly drilled.