MicroTouch Micro Touch Capacitive Controller MT3000, Справочное руководство, Страница: 28 / 64

MT3000 Capacitive Controller Reference Guide 28
Some possible reasons for a command failure include:
•
The command was not formatted correctly.
•
The system parameters were not set up to allow command execution.
•
The controller does not support the command.
The terminator is the last character of each response string and is an ASCII
carriage return CR. The hexadecimal code for the ASCII CR control
character is 0D hexadecimal. The value returned in the response will be the
ASCII control character for a carriage return, displayed on the screen as the
cursor moving to the next line.
In this chapter, responses are shown as a string of ASCII characters
consisting of a header, the response, and a terminator as follows:
<SOH> Response <CR>
Controller Initialization
To initialize the MT3000 controller for new development, send the
sequence of commands shown in Table 3. For controller responses to each
of these commands, see the firmware reference section at the end of this
document.