- 4 -
Installation
Important: Please use the installation procedure below. Improper, or no
operation may result if the start-up sequence is not correctly followed.
Figure 3
Installation of Optical HDMI extender
Installation Step
1.
Put „TX‟ module near to HDMI signal source, such as DVD players or
computers.
2.
Put „RX‟ module near to HDMI sink, such as LCD TVs or Projectors.
3. Connect HDMI cable from TX to Source. Also connect the HDMI cable
from RX to Sink.
4.
Connect each duplex SC fiber cable as indicated number. The channel “1”
of TX corresponds to channel 1 of RX. The other channels are the same
connection.
5. Plug in the 5V adapter to the electricity and TX/RX modules.
Note 1 : Clean end face of fiber before plugging in. The dust will cause damage to the fiber.
Note 2 : The length of HDMI cable should be
NOT
longer than 2 meters.
Note 3 : These three figures in front of the modules represent linking status. These 3 LEDs
will be bright greenly if all setups are complete and correct. The left one stands for
the connection of fiber. The middle one stands for the connection of HDMI source.
The right one stands for the connection of HDMI source.
Optical fiber HDMI source cable
HDMI sink cable
Multimode Fiber (2C)
200 Meter
LCD TV
HDMI cable
DVD Player
TX
RX
HDMI cable
