Trim 2mm off the end of each control surface to give
clearance for when it moves.
Use masking tape as shown to hold the control surfaces
in place if the wing has been pre-built and use blenderm
hinge tape to attach the control surfaces.
Procedure for Single Servo Above Wing Mount
Use a ruler and lay it from the hole in the aileron horn to
where the control horn will be placed and rule a line on
the control surface to indicate where to cut the slot for
mounting the control horn.
Glue the control horns in place and attach your control
linkages.
The servo will protrude under the wing surface so you
will need to cut a slot in the airframe here to accept the
bottom of the servo when the wings are attached.
Cut out a gap in the airframe here to allow the servo lead
to exit the airframe, and plug it into the aileron port on
your receiver.
