Bracket Mounting
This method allows for the easy removal of a NMEA Interface as
and when required for either security reasons or to prevent
damage whilst not in use.
1. Using the three supplied M4 bolts attach the back plate to the rear of
the NMEA Interface. (Fig. 1)
2. Drill three 3mm holes marked “BRACKET” on the Template and using
the supplied screws attach the clip bracket to the mounting surface.
(Fig. 2)
3. Place the NMEA Interface flat against the bracket slightly higher than
the final position and slide gently down into position. There will be a
small click as the bracket secures the Interface in position. (Fig. 3)
4. Connect and secure the cables leaving a loop of single core cable
inside the casing before fitting the cover such that the outer sheath is
secured beneath the rubber clamp. Once the Interface is secured in
position it is advisable to clamp the cables to the mounting surface
close to the Interface.
5. To release the NMEA Interface press lightly on the bracket tab and
slide the Transmitter up until it can be pulled away from the surface.
(Fig. 4)
Note: Take care to disconnect cables carefully before removing the unit
and ensure that the cables and connectors left behind are protected
from both water and physical damage.
Surface Mounting
With Rear Access
Position the supplied Template carefully before starting.
1. Drill three 5mm holes marked “B” on the Template.
2. Screw the four M4 brass studs into the rear of the Interface.
3. Place the Interface in position pushing the three studs through the
newly drilled holes.
4. Using the 3 supplied Thumb Nuts secure the Interface to the surface
making sure it is level before fully tightening.
5. Connect and secure the cables leaving a loop of single core cable
inside the casing before fitting the cover such that the outer sheath is
secured beneath the rubber clamp. Once the Interface is secured in
position it is advisable to clamp the cables to the mounting surface
close to the Interface.
Without Rear Access
Position the supplied Template carefully before starting.
1. Drill three 2mm holes marked “SURFACE” on the Template
2. Remove the cover of the Interface from the main body.
4. A the Interface to the mounting surface using the three self tapping
screws provided. Take care not to over tighten the screws as this
may cause the moulding to crack.
5. Connect and secure the cables as shown overleaf.
6. Carefully fit the cover securing the cables with the clamp bar.
