Communicate via
P/N 2300-0749
Quick Installation Guide
Model No.: SP6008P
8-Port 10/100M PoE Switch
6
5
7
CE Mark Warning
This equipment complies with the requirements relating to
electromagnetic compatibility of the essential protection requirement
of Council Directive 89/336/EEC on the approximation of the laws of
the Member States. Company has an on-going policy of upgrading
its products and it may be possible that information in this document
is not up-to-date. Please check with your local distributors for the
latest information. No part of this document can be copied or
reproduced in any form without written consent from the company.
WEEE Directive & Product Disposal
At the end its serviceable life ,this product should not be treated
as household or general waste. It should be handed over to the
applicable collection point for the recycling of electrical and
electronic equipment, or returned to the supplier for disposal.
w w w . m i c r o n e t . c o m . t w
Specifications
SP6008P
Model No.
Standards
Features
Pin Assignment
and Polarity
LED Indicators
PoE Power
Consumption
Power
Dimension
Weight
Environment
IEEE 802.3af/at PoE
IEEE 802.3 10 BaseT
IEEE 802.3u 100 BaseTX
IEEE 802.3x Flow Control
Number of Ports: 8 PoE/PSE ports
MAC Address: 2k
Buffer Memory: 768 bits
Transmission Method: Store and Forward
1/2 (+), 3/6 (-)
Per Port: Data, PoE
Per Unit: Power, PoE Max. A/B
DC Per Port Output- 30W Max on Port,
8 Ports at Full 15.4 W Output Supported
120 Watts (Max)
100~240VAC
44.5(H) x 280(W) x 179(D)mm
1.61 Kg
O
Operating Temperature : 0~50 C
Storage Temperature : -40 C to 70 C
Network Speed
Cable Type
10M
100M
Max. Length
Cat. 3,4,5,5e UTP/STP
Cat. 5e,6 UTP/STP
100 meters
100 meters
Connect To Ground
Connecting the switch to ground protects against lightning
over-voltage and over-current of the switch, which is also a
necessary measure to protect the body from electric shock.
In different environments, the switch may be grounded differently.
The following instructs you to connect the switch to ground through
the power cord. Connect the switch to ground in the best way
according to your specific operating environment.
Connect To Ground Through The Power Supply
If the switch is installed in a normal environment, it can be grounded
through the PE (Protective Earth) wire of the AC power supply, as
shown in the following figure 4
Connecting Network Device
For cable selection, refer to the following table:
The setup of the switch can be performed using the following steps:
Step 1:
Connect the Power Cord to SP6008P and then to a power
outlet.
Step 2:
Connect a RJ-45 Ethernet cable from IEEE802.3af/802.3at
compliant devices (PD) to an available PoE port of SP6008P.
Note:
Port 1 to Port 8 are used for connecting to PD or PoE splitter for
end
devices.
