MicroNet SmartHub LTE Underdash, Руководство по оборудованию

Страница: 21 / 29

Connector Signals Map
Overview
Rev. 1 SmartHub Underdash OBC Hardware Guide 21 / 28
5. Connector Signals Map
Overview
This chapter describes the SmartHub Underdash OBC interface connectors and signals found on the
main and secondary connectors.
The following abbreviations are used:
 I - Input signal
 O - Output signal
 B - Bus signal
 V - Voltage signal
 G – Ground
 P – Positive
 N – Negative
Interface Connectors
The SmartHub Underdash OBC interface contains Molex Pico-Clasp™ Wire-to-Board Header 1.00 mm
pitch 20 and 50 pin connectors. All pins are ESD protected (against electrostatic discharge). The
Main
Connector Pinout and Secondary Connector Pinout tables below describe the pinout of each connector.
Figure 9: SmartHub Underdash OBC Interface connectors