Physical Configuration
Dimensions and Weight
Form
factor
Capacity (GB)
Height
(mm)
Width
(mm)
Length
(mm)
Weight
(grams)
2.5-inch
200/400/480/800/960
7.00 +0.20/–0.50
69.85 ±0.25
100.24 ±0.21
TBD
1600/1920/3200/3840
15.00 +0.00/–0.50
Dual Port Support
Micron's 600 Series SAS SSD drives have two independent ports, which can be connec-
ted in the same or different SCSI domains. Each drive port has a unique SAS address.
The two ports are capable of independent port clocking. For example, both ports can
run at 12 Gb/s, or the first port can run at 12 Gb/s while the second runs at 6 Gb/s. Sup-
ported link rates are 3.0, 6.0, or 12.0 Gb/s.
Subject to buffer availability, SSD drives support the following:
• Concurrent port transfers: Supports receiving COMMAND and TASK management
transfers on both ports simultaneously
• Full duplex transfers: Supports sending XFER_RDY, DATA, and RESPONSE transfers
while receiving frames on both ports
Interface Connectors
The SAS signal segment interface cable has four transmission conductors and three
ground conductors for each channel. As shown in the figure below, the cable includes
two 7-pin signal segments (primary and secondary) and a 15-pin power segment ar-
ranged in a single row with a 1.27mm (0.050 inch) pitch.
SAS drives use the device connector for the following:
• DC power
• SAS interface (dual port)
• Activity LED (DAS)
Figure 4: SSD Interface Connections
Power segment
Primary signal segment
Secondary signal segment
P1
S8
S1
S600DC Series 2.5-Inch SAS NAND Flash SSD
Physical Configuration
CCMTD-1725822587-3891
s600dc_series_2_5_sas_ssd.pdf - Rev. H 9/17 EN
11
Micron Technology, Inc. reserves the right to change products or specifications without notice.
© 2015 Micron Technology, Inc. All rights reserved.
