Micron Wings Balsa Craft S.E.5a, Инструкции по сборке

Страница: 14 / 21

If you have purchased the complete kit version of this
plane, the “
Receiver 24R6CLV11 DSM2 Compatible
Linear 5Ch Brick” receiver board will be included. To use
this receiver you will need to reverse the direction of the
rudder and elevator servos by adjusting settings on your
transmitter.
Glue the control horns in place as shown here. Note: the
control horn with the longer base is for the rudder and
the one with a shorter base is for the elevator.
Step 11 – The Undercarriage
Attach the undercarriage as shown below. You may have to trim or sand the gaps in the joint to
ensure that the strut inserts all the way in to the position indicated on the image on the left.
To make the wheels, there are three discs to each one. The slightly smaller disc goes in between
the two others to make a small groove in the middle which the o-ring sits in. Glue these together
with the plastic part inserted to keep them aligned. Allow to dry fully before using a small amount
of glue to attach the o-rings. Work slowly and gently when attaching the o-rings.
Cut some 2mm lengths of the heat shrink tube and use these on the inside of the wheel as