CONNECTING THE CHIME UNITS
TO THE MAINS SUPPLY
Plug the chime units into a convenient
power socket and switch on the power
supply. The POWER ON LED will
illuminate (FIGURE 6).
To check the chime, press the bell push.
To change the chime, refer to CHIME
SELECTION JUMP LINKS opposite.
Should you wish to use two bell pushes then additional units can be
obtained from our Helpline service. Quote the channel code number
shown on the backs of the units and telephone 0870 241 3029.
POWER ON LED
LED lights on Bell Push
but Chime does not sound.
FAULT
CAUSE
Units out of range
(Max. 40 metres).
Bell Push and Chime not on
same channel.
Weak battery in Bell Push.
Chime unit not connected
to the mains supply.
Chime does not sound
plus no light on bell push
LED.
Flat bell push battery.
Check polarity of battery
in Bell Push.
Unit appears to work
erratically.
This may be due to the
mounting position, try
moving the chime
closer to the bell push.
MICROMARK INSTRUCTIONS MM25309/051005
© Micromark 2005
Page 2 of 2
INSTALLATION
WALL
PLUGS
FIXING
SCREWS
FIXING THE BELL PUSH
Use the bell push holder as a template
and mark and drill two fixing holes or
use the self-adhesive pads supplied
(FIGURE 4).
Use the screws and wallplugs supplied
and fix the holder to the mounting
surface (FIGURE 4).
Take care on
glazed units if drilling.
Place the bell push into its holder taking
care to locate the tab on the holder into
the bottom of the bell push (FIGURE 5).
FIGURE 4
FIGURE 6
FAULT FINDING
TAB
FIGURE 5
BEFORE INSTALLING
Remove the battery isolation tab to activate the bell push (FIGURE 1).
In the BELL PUSH UNIT, If you require to fit/renew the battery or change the
position of the chime selection jump link:
1.
Remove the bell push from its holder by releasing the catch from the slot in the
casing (FIGURE 1).
2.
Press in the tab with a screwdriver and part the bell push casing (FIGURE 2).
CATCH
REMOVE BATTERY
ISOLATION TAB
SLOT
TAB
FIGURE 1
FIGURE 2
When necessary, fit/replace the battery (12V MN21 alkaline type), between the
contacts, observing the correct polarity (FIGURE 3).
Always use Alkaline batteries. Failure to do this may cause battery corrosion and
invalidate your guarantee.
CHIME CHANGE JUMP LINK.
There are three chimes available:
Ding-Dong.
Ding-Ding.
Westminster Chime.
There are three pairs of jump pins determining the 'ding-dong', 'ding-ding' or
Westminster Chime.
The chime is factory set to a 'ding-dong' tone with the jump link connecting the first pair
of pins.
For a 'ding-ding' tone, remove the jump link and reposition it to connect the middle pair
of pins.
For a 'Westminster chime', reposition the jump link to connect the remaining pair of pins.
CHIME CHANGE
JUMP LINK
FIGURE 3
Please note that this equipment and its components have NO user serviceable
parts.
If you experience any difficulties call our Helpline or write to:
Micromark Customer Service
Unit B1, Senator Point, South Boundary Road, Knowsley, Liverpool L33 7RS.
MICROMARK HELPLINE TEL: 0870 241 3029
Monday to Friday (8.30am to 5pm)
www.micromark.co.uk
PLEASE NOTE:
If an additional bell
push or chime unit are used, the
channel code number in the new
units must match that of the existing
bell push and chime unit.
CUSTOMER SERVICE
HELPLINE
0870 241 3029
