6
Maximum
Water Level
How to start the unit
1. Open the access door for filling water, pour water into water reservoir through the funnel.
Fill with potable water only.
Keep water level below the “MAX” water level mark.
Filling the
water here
Funnel
2. Press “Power” button on the control panel to begin the ice making cycle.
3. The default size of ice-cube is Medium. If you want to select the size of the ice cube, just
press the “Select” button. If the room temperature is lower than 60
℉
, it is recommended to
select the small size in order to avoid ice sticking together.
4. The ice making cycle lasts 6 to 13 minutes, depending on the size of the ice cube selection
and the ambient temperature. In the extreme hot room temperature, ice-making time may
vary a lot.
5. While the icemaker is on, check the water level periodically. If water level is low, the ice
maker will stop automatically, and the “Add Water” indicator light will come on.
Press “Power” button, fill water up to the level mark, and press “Power” button again to turn
on the unit.
Allow the refrigerant inside the compressor at least 3 minutes to settle before restarting.
When Ice Full indicator is on
6. When the ice maker is completely full, it will stop producing ice and the “Ice Full” indicator
will come on.
USING YOUR ICE MAKER
