EN
12
Error
Description
Potential cause and remedy
«ERR 1»
Signal too weak
The pulse signals on the cuff are
too weak. Re-position the cuff and
repeat the measurement.*
«ERR 2»
Arm movement
During the measurement, error
signals were detected by the cuff,
caused, for instance, by movement
or muscle tension. Repeat the
measurement, keeping your arm still.
«ERR 3»
No pressure in
the cuff
Adequate pressure cannot be
generated in the cuff. A leak may
have occurred. Check that the
cuff is correctly connected and
not too loose. Recharge the
batteries if necessary. Repeat the
measurement.
«ERR 5»
Abnormal result The measuring signals are
inaccurate and no result, therefore,
can be displayed. Read through
the checklist for performing reliable
measurements and then repeat the
measurement.*
«ERR 6»
MAM mode error There were errors during the
measurement in MAM mode,
making it impossible to obtain
a final result. Read through the
checklist for performing reliable
measurements and then repeat the
measurement.*
Low battery
The battery power in the Microlife
Blood Pressure Monitor
Dock is too low. Charge the dock
before taking any measurements.
* Consult your doctor, if this or any other problem occurs repeatedly.
Error Messages
If an error occurs during the measurement, the measurement is
interrupted and an error message, e.g., «ERR 3», is displayed.
