Microlife BPB3 BT, Руководство пользователя

Страница: 8 / 10

6
8. Error Messages
If an error occurs during the measurement, the measurement is
interrupted and an error message, e.g. « Err 3 », is displayed.
* Please immediately consult your doctor, if this or any other
problem occurs repeatedly.
9. Safety, Care, Accuracy Test and Disposal

Safety and protection

Follow instructions for use. This document provides important
product operation and safety information regarding this device.
Please read this document thoroughly before using the device
and keep for future reference.
 This device may only be used for the purposes described in
these instructions. The manufacturer cannot be held liable for
damage caused by incorrect application.

This device comprises sensitive components and must be treated
with caution. Observe the storage and operating conditions
described in the «Technical Specifications» section.

Protect it from:
- water and moisture
- extreme temperatures
- impact and dropping
- contamination and dust
- direct sunlight
- heat and cold

The cuffs are sensitive and must be handled with care.

Do not exchange or use any other kind of cuff or cuff connector
for measuring with this device.

Only pump up the cuff once fitted.

Do not use this device close to strong electromagnetic fields such
as mobile telephones or radio installations. Keep a minimum
distance of 3.3 m from such devices when using this device.
 Do not use this device if you think it is damaged or notice
anything unusual.
 Never open this device.

If the device is not going to be used for a prolonged period the
batteries should be removed.

Read the additional safety information provided within the indi-
vidual sections of this instruction manual.

If you suffer from a cardiac arrhythmia consult with your doctor
before using the device. See also chapter «Appearance of the
Irregular Heartbeat (IHB) Symbol» of this user manual.

The measurement results given by this device is not a diag-
nosis. It is not replacing the need for the consultation of a physi-
cian, especially if not matching the patient’s symptoms. Do not
rely on the measurement result only, always consider other
potentially occurring symptoms and the patient’s feedback.
Calling a doctor or an ambulance is advised if needed.
Error Description Potential cause and remedy
« Err 1 »
AS
Signal too
weak
The pulse signals on the cuff are
too weak. Re-position the cuff and
repeat the measurement.*
« Err 2 »
BT
-B
Error signal During the measurement, error signals were
detected by the cuff, caused for instance by
movement or muscle tension. Repeat the
measurement, keeping your arm still.
« Err 3 »
BT
-C
Abnormal
cuff
pressure
An adequate pressure cannot be gener-
ated in the cuff. A leak may have occurred.
Check that the cuff is correctly connected
and is not too loose. Replace the batteries
if necessary. Repeat the measurement.
« Err 5 » Abnormal
result
The measuring signals are inaccurate and
no result can therefore be displayed. Read
through the checklist for performing reli-
able measurements and then repeat the
measurement.*
« Err 6 » MAM Mode There were too many errors during the
measurement in MAM mode, making it
impossible to obtain a final result. Read
through the checklist for performing reli-
able measurements and then repeat the
measurement.*
« HI » Pulse or cuff
pressure too
high
The pressure in the cuff is too high (over
299 mmHg) OR the pulse is too high (over
200 beats per minute). Relax for 5 minutes
and repeat the measurement.*
« LO » Pulse too
low
The pulse is too low (less than 40 beats
per minute). Repeat the measurement.*
Problem
with Blue-
tooth
®
connection
If any problem occurs with the Bluetooth
connection, the Bluetooth
®
icon
AL
blinks rapidly for approximately 10
seconds. To solve the problem, please
visit www.microlife.com/connect.