Microlife 47038, Руководство пользователя

Страница: 20 / 65

20
aponorm ® by
X
To set a second alarm time, proceed as above but if the « 1 »
flashes, press the M-button to select « 2 » and confirm with the
time button.
X An active alarm time is indicated by the bell symbol in the display.
X The alarm will sound at the set time every day.
X
To switch-off the alarm when it is sounding, press the ON/OFF
button
1
.
X To permanently switch off the alarm, proceed as above and select
the crossed-out bell symbol. This will then disappear from the
display.
X The alarm times must be re-entered each time the batteries are
replaced.
AK
appears in the bottom left of the display. Then release both
buttons. The flashing « 1 » in the display indicates that the first
alarm time can now be set.
2. Press the time button to set the hours – the hour display flashes
and pressing the M-button allows you to set the alarm hour. To
confirm, press the time button.
3. The minute display will now flash. The minutes can be set using
the M-button. To confirm, press the time button again.
4. The bell symbol will now flash. Use the M-button to select
whether the alarm time is to be active (bell) or inactive (crossed-
out bell). To confirm, press the time button.
How not to store a reading
Press the ON/OFF button while the reading is being displayed.
Keep the button pressed until «
M » is flashing and then release
it. Confirm by pressing the M-button.
1
AL
Memory full
When the memory has stored 200 results, the display shows
«
Full M » after a measurement. From this point onwards, a
When the memory has stored 99 results (99 memories per
user), the memory is full. From this point onwards, a new
measured value is stored by
overwriting the oldest value .
Clear all values of an individual user
The following procedure applies to the user selected, 1 or 2. If you
are sure that you want to permanently remove all stored values,
hold down the M-button (the instrument must have been switched
off beforehand) until
«CL» appears and then release the button.
To permanently clear the memory, press the M-button while «CL»
is flashing. Individual values cannot be cleared.
6. Setting the Alarm Function
This instrument allows you to set 2 alarm times at which an alarm
signal will then be triggered. This can be a useful aid, for instance as
a reminder to take medication.
1. To set an alarm time, press the time button
6
(the instrument
must have been switched off beforehand) and immediately after-
wards the M-button
5
and hold both down until the bell symbol
7.